Repair of failed Nintendo Switch Modding

Have you or someone else tried to mod a Switch without it working as it should? I offer a service for those who have already installed (or had installed) a modchip, but something went wrong – whether due to errors in the installation itself or issues with the software setup.

If you can only access the original firmware and not Hekate after installing a modchip, it means some of the solder points are incorrect.

If you get an error message when trying to enter modded firmware, it's a software error.

We fix both!

🎯 What I offer:

   -I troubleshoot both hardware and software to find out why the modchip isn't working.

   -I correct any errors in the installation (e.g., poor solder points or misplaced wires).

   -I set up the necessary firmware/software again where needed.

   -The goal is to get the Switch fully modded and in working order.

   -If you get a purple screen after attempting a mod, it can be fixed!

NB! This is a repair of custom firmware/modchip. This depends on you still being able to access the original firmware. If you CANNOT access the original firmware, it cannot be repaired!

⚠️ Important to know: In some cases, previous modding attempts have led to damage to the motherboard. If the motherboard is severely damaged, it may be impossible to repair the console. I always do my best, but cannot guarantee success in extreme cases.

💰 Refund for unsuccessful attempt: If, contrary to expectations, I am unable to get the console modded and running, you will receive a 70% refund of the price of this service.

If you have used a cheap SD card from Aliexpress or similar, you must have a new SD card for it to work. Please select a new SD card and size below!